374262R91 was a distributor shaft, 2 springs and the pin for the distributor shaft gear all under the one #. Parts are sold individually now. Shaft 362723R91, springs 372785R91, and the drive pin 70916202. If the firecrater pistons check out okay I use them with new sleeves. Figure there made out of better stuff than the replacements. If decided to use lower compression and the tractor never worked hard the 30 degree original SM advance could probably be used. Looked for a note of the advance rate springs used with the original 374262R91 kit. Didn't find where it was at the first look. Yes the L22 means the distributor will advance from 0 up to a total of 22 crankshaft degrees if everything is correct. In case something was off a little IH wanted you to play it safe and set the time at 22 with the engine at full RPM and let the low speed time fall to around 0. Templet to mark the front engine pulley for 22 degrees was in a firecrater kit. Think I can get a NOS distributor shaft at a lot better price than a dealer if you decide to replace.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.