Posted by danto on June 17, 2012 at 12:58:43 from (98.125.87.207):
I am installing a baler mounted moisture tester on my baler and am looking for a source for power to it from the tractor. I will be using an IH 584 or a Case IH 885 tractor. Both have tailer sockets on them, but only have power to two terminals for the turn signals/flashers. Owners manual says the other pins can be wired for power. There seems to be wires to the back of the socket, but am wondering where the other ends are under the hood and where they should be hooked up? Also, where can I buy the receiver to plug into socket. It is different than a regular trailer light socket. Haven"t called the CaseIH dealer yet to see if they have them. I was just thinking since I may be using either tractor on the baler, it would be easier to be able to plug into the trailer socket, rather than wiring into the ignition switch or somewhere else on both tractors. Thanks for any and all help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.