Posted by I544 on June 15, 2012 at 19:51:02 from (65.61.92.221):
I have a I544 with I think the C200 engine. I have the gas tank that is above the starter. My gas goes from the tank to the sediment bowl to the other side of the tractor to a mechanical fuel pump. From the fuel pump it goes to the otherside (right side) to the carburator.
I have removed the line from the sediment bowl and got fuel flow. I then went to the inlet side of the fuel pump and got fuel flow. I then went to the outlet side of the fuel pump and had no fuel flow. I then motored the engine and still had no flow from the fuel pump.
I removed the pump and pushed on the cam arm of the pump and it pumped fuel. I then replaced it and motored the engine and it still did not pump.
So I am wondering what is going on??? I did read that the I544 was a gravity flow system. Is that correct or does anyone have an idea of where I should go next.
Is there a possibility that my cam is bad that is suppose to operate my fuel pump and how would I check that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
