Thanks for the tips guys. I checked it tonight, all the connections on the back of the meter are tight and no obvious shorts in those wires. The seal under the steering wheel had been leaking, I just fixed that not too long ago so there very well could be some residual hydraulic fluid hanging around back there behind the regulator. I took the cover off the regulator and there wasn't anything obvious in there but there were traces of fluid around the edges but it looked like the gasket had kept it out of the internals.
There was however a faint burned hole in the main feed line going to the glow plugs that I must have missed in my initial look so hopefully that's the cause. Must have been shorting against one of the injector lines.
So next question - can I just replace the quick connect that's shorted or should I replace the whole wire? It went up and over the engine and I lost it there so I'm not sure where it goes. Does the power go anywhere after the meter before it gets to the plugs? Surprising it's not more of a straight shot. Not sure what caused the short though, could the regulator have been sending too much juice? Is there a way to test it?
This post was edited by Steve KS at 17:53:16 06/07/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
