Farmall & IHC Tractors Discussion Board |
Re: Super A Three-Point Adapter help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on September 27, 2000 at 19:35:22 from (129.37.117.209):
In Reply to: Super A Three-Point Adapter help posted by TonyG on September 27, 2000 at 15:58:39:
I used to have a Super A and then a 140 with a 3 point adapter. The top link connection was mounted on the rockshaft cross bar. It requires a short top link. The normal longer ones you see won't work. The one I had did not work too well, so I eventually had a welding shop fabricate a top link connection that was bolted to the drawbar mounting bolts. It was better, but still not exactly right. If you decide to make one, I'd suggest putting 2 or 3 holes at different heights, so you have a choice where to attach the top link. You will still have to have the short top link, so best to try to find somebody that sells the conversion to get just the top link bracket and the short top link.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|