Posted by sgtbull on June 05, 2012 at 18:54:16 from (163.191.228.254):
I always wanted an old truck, but to buy a restored one cost too much, and to restore one right cost even more... so, I built one. I liked the Model TT "c" cab design, the Mack truck roofline, the Rumley iron radiator and a flare bed box... this is what I ended up with:
Although its not really a McCormick Deering truck, at least the radiator is. If you look close, you'll notice that it came from an early tractor.. 10-20, 15-30 or 22-36.. I really don't remember what I got it off of. It took me about 6 months to build this and I have had more fun with it than a body should. Here's how it breaks down:
Frame. 1959 Chevy 3/4 ton.. from a fence row.
Engine. 1960 something 235 straight 6. It came from a truck I drove in high school, that was eventually sent to a scrap yard after the boys in shop class rebuilt the engine. It smoked like a bear and used copious amounts of oil when they were done. 30 yrs later, I buy it for $50.. and find that they had lined up all the rings. It runs like a champ and burns zero oil.
Radiator.. as previously mentioned.
Transmission, out of a '59 Chevy truck
Gauges out of a '52 GMC
Steering wheel off of a '29 Chevy
Headlamps from a Diamond T Truck
Every thing else, I built. The cab and bed are made from an oak tree I cut down and had sawn. All the metal came from a local iron supplier. The hood I formed with a rubber mallet and then had a buddy w/a louvre press punch the louvres in. It turns heads and gets lots of comments... and, its a lot of fun to drive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
