Before starting - take pictures of EVERYTHING from every angle. Most stuff will go back together in an obivous way - but there's always one or two items where you'll really appreciate a good picture.
Start a spreadsheet and make a REAL budget. You might be surprised at how quickly the costs add up on all the little parts. Doing it in your head usually leads to underestimating.
And right from the start - you really need to establish a goal for what you want for an end result.
I struggled with that - the tractor we just did was never intended to be a show tractor - but I kept wavering, thinking it would be nice to make it perfect...
I finally had to make up my mind that it WAS a work tractor - and kept reminding myself of that for every decision.
I also would not have wanted to do it without a sandblaster. You don't NEED one - but I found the sandblaster invaluable. But you really do have to be extremely careful with where the sand ends up.
If you sand blast parts, power wash grease first - thick grease/dirt wastes a LOT of sand when blasting.
I also think painting everything together would have been a better plan than painting parts individually like we did - wasted a LOT of time, AND paint.
We painted one part here, one there... Would have been better to prep everything and paint all at once - and in place when possible.
Keep nuts and bolts loosely in place when you take stuff apart. Don't just drop them all in a bucket as you go. Saves a lot of time later.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
