Posted by Farmallb on May 19, 2012 at 09:18:17 from (67.142.178.20):
HOW in the world did they decide what size to make the hand hole for adjusting the clutch> Im thinking somebody there had a baby and they stuck its hand in a series of holes till they found just the one that didnt bruse its hand too much going in and out, and used that dia for the hand hole. I cant see (LITERALLY), I cant see how to get something in there to pull the pin, and I sure as heck cant see how youd ever find the hole to put it back. My fingers can just touch the pin ends, and thats it. Is there a trick Im missing,
OTHER, Than to find somebody with younger, smaller hands whos a machanic and let them do it??
Im more inclined, if I have to get a machanic to do it, to go ahead and replace clutch plate and pressure plate at the same time. If I only have him in to adjust the clutch, and pay him for that, and that dont do it, and we have to tear it down anyhow, then ill be paying him as much IF not a bit more anyhow. With it all done at the same time, I can be way more assured of it being done and finished. Besides being my lawnmower, and weak left arm, its also my hoveround.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.