This is certainly an interesting discussion. My philosophy in this matter is that the sleeves look like they have very little wear and there is no ridge at the top, therefore I am not certain that they are worn beyond spec or to the point that it would bother me for what I am going to do with the tractor. If I get the tractor running and it smokes or clatters or otherwise shows that it needs a rebuild then I will rebuild it. If it has good power and does not smoke or make bad sounds I will happily leave it unrebuilt, since I do not put enough hours on my tractors to make much of an issue. I guess what it comes down to for me is that I would rather take a chance on a $120 price to get it running and see what it needs than pay $500 up front to rebuild it. If I need to rebuild it I will have wasted $120 whereas if I do not need to rebuild it and I do anyway I would have wasted $380. Maybe not the best reasoning but I am a cheapskate. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.