Yes, a wiring diagram would be very helpful. Measured current flows through the ammeter. This means that the ammeter must be wired in series as a part of the charging circuit between the battery and the alternator. If you wire it up in parallel, it will not work. If you wire a voltmeter up in parallel it will work perfectly.
If you had a sufficiently large ammeter, with a reading of say 200-0-200 then you could simply connect it between the battery terminal and the wire leading to the starter motor and alternator etc. This would show all charge and discharge including current flow through the starter while it operates. If you do this with a standard ammeter and then press the starter button the result will be smoke and/or sparks and fire.
Of course, if you are as stubborn as me and live in a place where IHC used Lucas equipment, then you have all the fun of Lucas 6 and 12 volt systems running positive Earth as per Farmall M, AM, AMD, AW-7 etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.