Farmall & IHC Tractors Discussion Board |
Re: starter brushes for 1948 Farmall Cub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill {Antique Acres} on September 24, 2000 at 20:41:20 from (63.162.254.101):
In Reply to: starter brushes for 1948 Farmall Cub posted by Calvin Robinson on September 24, 2000 at 17:10:13:
I had to replace the gear a while back and searched high and low for it. I called every parts place and NAPA even couldn't get it. I ended up having to get it at the friendly Case/IH dealer. It is not cheap either. If memory serves me right in the neighborhood of $30. I just had to replace my rotor last weekend and it was $24. If you can find one in a graveyard that would be good. But make sure the teeth are in good shape on the gear and the rotor. The old ones are metal and the new ones are plastic if you do buy a new one. Bill {Antique Acres}
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|