I put my wheel weights on Sunday afternoon, I put both weights on the land (left) side. The bolt specs were provided by FarmallHal, he got them from his Farmall IH Parts Catalog.
For the first set bolted to the cast iron center: 3/4" x 4 3/4" NC machine bolts along with 3/4" lock washers and hex nuts.
For the second weight that bolts to the first weight: 3/4" x 3 3/4" NC machine bolts along with lock washers and hex nuts. washers should be 1 1/4" OD x 25/32" ID 10 gauge.
I ended up purchasing the bolts from fastenal.com, for the first set instead of 4 & 3/4 length I went with 5", for the second set instead of the 3 & 3/4" length I went with 4"
first set: http://www.fastenal.com/web/products/detail.ex?sku=20373 Fastenal part no 20373 ¾-10 x 5” plain finish square head bolt $4.42 each
second set: http://www.fastenal.com/web/products/detail.ex?sku=20369 Fastenal part no 20369 ¾-10 x4” plain finish square head bolt $3.65 each
I got lock washers and hex nuts from tractor supply as well as 1 1/4" machine bushings that I put behind the lock washers.
Each weight is 145 lbs, I lifted a weight to the cast iron center, lined up the holes and had my wife slip the top bolt in and finger tighten the nut. Then I was able to put in the other 3.
I used the method of 1st weight to wheel center and 2nd weight to 1st weight because I was lifting them by hand, but another method is getting longer bolts and connecting both weights with the 4 bolts instead of 8. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
