Posted by Lmack on April 20, 2012 at 21:41:47 from (24.131.58.167):
In Reply to: Super C disk brakes posted by BoonvilleKid on April 20, 2012 at 21:16:38:
These disk are supposed to be dry and free of oil. If the oil seal is leaking and the disk and friction surfaces are oily, it will cause the breaks to grab. First try using regular break cleaner to remove oil if you see any and that should solve the grabbing problem. You then have to find the source of the oil and get it stopped. It could be water in the trans/rear end. Check the oil level in the case by removing the plug under the operator platform on the rear right. If it is high try removing the main drain at the bottom and drain any water in the case. When oil comes out replace the plug. I would almost bet you have water in the trans/rear end. It may also be a bad oil seal. Enjoy!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.