Posted by TimWafer on April 03, 2012 at 16:23:43 from (74.39.163.74):
I need to adjust the width of the front wheels on my Farmall 656. Its got just the straight tubular axle and currently the wheels are all the way in. I need to move each out about 6”. I got the clamps and the pins out but have tried about everything I can think of to break the tubes loose. So far I’ve heated the outer tube with the acetylene torch as hot as I can get it. I can just get a faint redline down one side at a time. Torch just isn’t big enough. I’ve plugged the lower holes and poured tranny fluid in the tube and let it soak for a couple days. I’ve rigged up hydraulic jacks on two sides and jacked them to their capacity (and beyond) trying to slide the tubes apart, all to no avail. Hasn’t budged a fraction! These buggers are really stuck. Oh, I’ve also beaten my brains out with a sledgehammer. Anyone got any other tricks? Am I possibly missing something? About all I can think to do at this point is completely remove the axle and try to get the thing red hot by some other means. I’ve got one of those big propane weed burner type torches but don’t know if that would work or not. Also worried about ruining any temper in the axle. Don’t know if that’s a concern? Tim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.