Farmall & IHC Tractors Discussion Board |
Re: Re: Replacing rear axle outer ball bearing on an M?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Is 450 same deal? on September 18, 2000 at 17:04:13 from (207.177.47.190):
In Reply to: Re: Replacing rear axle outer ball bearing on an M? posted by The Red on September 18, 2000 at 14:44:18:
Red and All- Thank you for these posts. You're getting ahead of me in my 450 renovation quagmire... My 450 has the outer cap broken away at about a 45 degree angle slicing thru the grease fitting hole. The cap is intact and functional. It's just that the grease fitting and hole have obviously been damaged for a long, long, time. It was not noticable 'till I pulled off the home made tools & junk boxes gadget built over it. Please, expand on the telling about pulling that bearing and repairing that cap. I can drill, re-thread, and install the grease fitting, no sweat. My gut hunch is to simply replace the bearing and install a new grease fitting. What else? Please, 'yall keep talking and throwing out ideas, 'cuz you really got my attention on this one. Big grin, IHank
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|