Posted by AG in IN on March 25, 2012 at 07:59:42 from (67.236.90.241):
In Reply to: 1963 560 diesel posted by windhillfarmer on March 25, 2012 at 06:52:57:
Early 560's had rear end issues, but if it's a '63, those issues would have been remedied by IH by then.
Everybody complains about the glow plugs. Few bother to replace them. 6 good glow plugs are essential for starting these engines.
If it has the sleeves in the diesel engine that use shims to adjust the sleeve standout, the sleeves don't press fit in the block and can occasionally start dancing around in the bore especially if the proper shims weren't used.
These engines could have used at least a half-dozen more head bolts, but there is no place for them. Head gasket failures are more common than other series of IH diesel engines.
My dad's 560 diesel got to where it was blowing head gaskets about once a year. He had the block bored and sleeves with an oversized outside diameter to fit the new bore for the later style engines installed that press-fit into the block installed. He studded the block and threw the head bolts and the pipe spacers in the trash. No more shims, either. About 5 years and 2500 hours later it has some decent power and no problems. The only thing he perhaps should have done is put a later style head with the bigger valves on it.
A later 560 should have the clutch type PTO that is adjustable on the tractor. It should have a plug on the top that looks like a big nut. With the earlier clutch type PTO's the rear end oil had to be drained and the unit had to be removed from the tractor to be adjusted. There was a band-type PTO used on the earliest 560's.
AG
This post was edited by AG in IN at 08:15:06 03/25/12 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.