Posted by Mike1972chev on March 23, 2012 at 16:07:19 from (108.67.94.194):
Hey,
When I put my wide front end on my Super M,I lubed the ball socket with bearing grease when I assembled it.THAT was over 11 years ago!!! And that was that(wasnt even thinking about it ever again???) One day When I was doing the regular greasing of ALL of the zerks,it finally "sank in" that this area had NEVER been lubed in over a decade!!!!!I pulled the aluminum cap off and it was dry as a bone!
There are ALOT of grease zerks on an M,but what blows my mind,there is NOT one for the stay rod ball socket???? What the crap????
Simple fix,I just added one,I thought about the aluminum cap first,but it seemed WAY to thin to drill and tap.I thought it might weaken it also,AND the threads would be into the ball stud..So I drilled and tapped the cap its self.It is a tight area between the 3 bolts.So I took a 1/16" bit and drilled straight into the face of it,between the bolt pattern,HALF way the thickness of the body of the ball socket.(As seen in the photo.)After some carefull measuring,I took the same 1/16 bit and,starting in the socket area,drilling 90 degrees back toward th first hole,drilling into it.Finishing up,I went back to the face of the socket,and with a #7 bit drilled in slightly LESS the thread length of a 1/4 threaded grease zerk and then tapped it.
Now I can shoot some grease to this socket every time I lube the rest of the tractor.It will keep it lubed AND push the "crud" out of it that accumulates during normal use(metal debris,dust,weeds,ect.)
Like I said,just something SIMPLE to do,but is helpful! This will work on ALL IH wide fronts with the wishbone ball socket(H thru 1066 or more????) I DO NOT know why IH never did this from the factory?????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
