Posted by Senator on March 22, 2012 at 19:17:28 from (72.37.249.84):
What purpose did the springs on the radiator mounting studs serve? I am assuming they offered some flexibility if the frame moved around a little bit so the studs did not rip out of the bottom of the radiator.
I'm asking because after replacing the original (wore out) radiator with an aftermarket copy I just can't get my hand in there to compress the spring enough to get the nut started. After a couple hours trying with lots of frustration, I am considering just using a washer and nylock nut without the spring (not too tight).
The aftermarket radiator does not have the mounting studs brazed into the bottom of the radiator as in the original, but are welded to a piece of heavy sheetmetal running underneath the radiator core. So I guess if there was some flexing the sheetmetal would flex and even if the stud welds broke eventually it would not damage the core.
Am I thinking right, or should I spend more time trying to get the springs on?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.