Farmall & IHC Tractors Discussion Board |
Re: Tuning C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kendall on September 11, 2000 at 07:54:54 from (207.136.53.43):
In Reply to: Tuning C posted by FC on September 11, 2000 at 05:17:06:
The manual says .020 for points with distributor and .013 with magneto. I just took my distributor apart and found the mecanical advance parts were so worn that the weights were rubbing the inside of the distributor. If your's is worn as bad, it could explain the erratic behavior at higher speeds. To set the timing, align the timing mark located on the flywheel with the mark on the housing so that #1 is at TDC. The timing mark is a line with "D-C" & "1-4" on either side. Its is very faint and may be hard to find if you flywheel is dirty. The indicator on the housing is at the very bottom. You can see all this through the hole on the bottom of the clutch housing. Once this is done, make sure the distributor's rotor is pointing toward #1 plug wire, retard the timing by rotating the distributor in the same direction that the cam rotates so that the points are closed, and with the hot wire of the coil near ground, advance the timing by rotating the distributor the other way slowly until the points open and a spark occurs. Lock the distributor down there. This is the correct setting for your engine and the rest of the timing advance occurs in the distributor with the mechanical advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|