Posted by Janicholson on February 06, 2012 at 14:12:55 from (199.17.6.82):
In Reply to: cub not charging posted by John E/Pa on February 06, 2012 at 13:54:40:
With A cutout system, and a 4 position light switchL The F terminal on the Gen is hooked to the wire coming from the light switch. It will be attached directly from the part of the light switch that is grounded, not the part that is powering the lights. The field resistor on the switch is in the circuit only in the L position, all other (HDB) are direct to ground. Again do not connect it to the light (powered) terminsld, it will not work. The A terminal on the gen goes to the Gen (or ARM) terminal on the Cutout. Should be 10ga wire. From the Bat terminal on the cutout, a 10Ga wire goes to the load side of the amp meter (not the side connected to the starter switch) First step is to polarize using a solid copper wire (tractor off) to jump between the Bat terminal and the Gen terminal. This polarizes the generator. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.