I use a hybrid of Jim and CNKS, but then they both helped me learn so that should not be surprising. I take cardboard boxes and poke holes with a screwdriver, inserting bolts in holes. They are first cleaned on a wire bench grinder. I map the position of the bolts and where they come from on a pad of paper because you will paint over your labels on the cardboard. On reassembly I use the pad as a general guide and a parts book for exact sizes and just make sure I get the right sizes in the right places. Damage is minimal with good paint on a clean surface but I do use a small paint brush and a bit of paint in a cup to touch up the small dings from the wrench.
Nuts/washers are laid out flat and painted one side and then the other or replaced altogether with new that I have pre painted. I don't much care for wasting a lot of time on rusted nuts.
Cotters and other odd parts are either hung from wire or laid out flat and frequently just replaced with new unless they are an odd size.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.