Posted by CNKS on February 04, 2012 at 18:17:53 from (216.144.104.128):
In Reply to: Farmall A starts hard posted by dahlin on February 04, 2012 at 13:47:08:
2 gauge cables work fine for me, and are easier to bend and install in a rather cramped area if you have the battery in a box. Make sure the battery will hold a charge or get a new one. Clean the battery connections and all places where the cables attach. The connections are more important than the cable size. Assuming that you installed the mag correctly, put the #1 piston at TDC, push the top of the mag against the block, the pull it out until it trips. When cold, turn the starter over, pull out the choke for 2 or 3 revolutions, then push it back in. Any more and the engine will flood. Pull out the choke slightly after it starts to keep it running. Also, go to Walmart and buy a battery maintenance thing to keep the battery charged--$20.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.