Posted by Owen Aaland on February 04, 2012 at 01:27:28 from (216.47.33.65):
In Reply to: 706 alt. light posted by morris roessler on February 04, 2012 at 01:02:07:
IH liked to us red wire as ground circuit wires. Reverse the leads and you should have a positive reading. Better yet measure the voltage between a chassis ground and each side of the socket.
If you have 10.24 volts across the socket with the bulb installed either you have a poor connection at the socket or the bulb is bad. If the voltage reading is without the bulb installed you may have a poor connection between the bulb and the switch.
There is a resistor wired in parallel with the bulb so you will not get battery voltage across the socket. That is why when you turn on the ignition switch the Gen bulb will glow dimmer than the Oil bulb.
The bulb used in those sockets is a number 257 which is a flashing bulb. They will sometimes get a high resistance internally across the flasher contact inside the bulb so they may not work even if they look OK. You can use a number 1895 bulb as a replacement and eliminate the flashing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
