Farmall & IHC Tractors Discussion Board |
Re: throttle problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on September 09, 2000 at 14:11:30 from (38.31.74.200):
In Reply to: throttle problems posted by shawn on September 08, 2000 at 17:52:45:
Sounds like you could have a fuel flow problem, leaning out on quick acceleration. Make sure you don't have any intake manifold air leaks. You might try pulling the drain on the carb make sure you get good flow. Your needle valve could be sticking in the closed position. When the engine draws a lot of fuel, the inrush of fuel refilling the fuel bowl causes the float to rise and the valve to stick, leaning the engine out until the float falls again. This could be caused by a bad needle valve, seat, or possibly the float rubbing on the carb just at the high position. And this will be a slow cycle. Slow acceleration never causes the float valve to shut entirely. I've never had governer problems on a Farmall so I don't know how they act, but I would think it would be a fast cycle.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|