You indicate that it is a pulling tractor, that kind of changes a lot of things. It may be pretty high compression, timing, who knows where it is set at, no doubt for maximum power under pulling conditions. Far as the spark advance, that occurs with engine rpm and totally dependent on how distributor is calibrated. In other words, it will advance the spark as engine rpm increases and retard as it decreases and has nothing to do with the throttle setting when engine is not running. I fought 6 volt starting systems for years. The last really hard starting gasoline engine IH made was the first 450 gas tractors. About half way through production they switched to 12 volt systems and problem solved. Many M's are on 12 volts now and most stayed with the 6 volt starter and it works out quite well. One thing, they do not have the initial torque to get that engine started turning, but once it turns just a little, they spin it like heck. Being a six volt starter it has much lower resistance so will really draw a heavy current for a few seconds until it gets it turning. This is normally not a problem but with a higher comp engine and cold thick oil it may very well be a problem. You may want to get that starter converted to 12 volts also if it is not. Far as solenoids, well, if you can get a really heavy one it is good, but most of them are no heavier in the contacts than the original push switch, just that they slap the contacts together good and hard. You of course need good clean, heavy connections all the way through and ground the battery right on starter mounting bolt for best results.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
