Farmall & IHC Tractors Discussion Board |
Re: Tire size
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Binder on September 07, 2000 at 09:58:34 from (206.5.110.15):
In Reply to: Tire size posted by Whiskers on September 07, 2000 at 06:00:24:
Disclaimer..I am pretty far from being an expert...but I don't know how much trouble you would get in, but it can be done. My Super H has standard rims and 15.5 X 38s on it. By my calculations, the tires would be 69" in diameter versus 60 1/2" for 11.2 X 38s...this is a pretty substantial difference (14% larger)which would translate into 14% more speed in any gear (you should get about 18-19 MPH in road gear). Keep in mind that this will raise you rear end by about 4", so you will kinda look nose down and this higher center of gravity could increase the likelyhood of a rollover (My Super H has a wide front and oversize tires there too, so it isn't too bad) (BTW I didn't put these on, the previous owner did and I would not, if for no other reason than looks...big tires on an H just look funny to me). But you do get the floatation and lower ground pressure. So it really comes down to your desired usage..I assume you are taking these off another tractor or have them sitting around or they are real cheap. But if lower ground pressure, floatation and less tire marks are important, then go for it. If you just need good all around tires, I would stay closer to stock.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|