Sounds like the sector gear was not tight on the pivot (vertical) shaft splines. The gear and shaft should be rock solid together when the top nut is tight.
Quoting Removed, click Modern View to see
That says the upper bushing is shot. Presuming the bearing surface on the pivot shaft is not worn, replacing the upper bushing should eliminate the front-back movement of the pivot shaft/gear.
C&G sells the upper bushing singly. I bought one several years ago - seems it was around $20.
----
Sounds like the thrust bearing and the lower bushing are in good shape. I'd leave both alone. Even a slightly worn lower bushing will not cause steering wobble - it's a worn upper bushing that causes most problems.
Quoting Removed, click Modern View to see
There's no seal above the lower bushing/thrust bearing. Could it be the seal at the bottom of the gear box dropped out and slid down the shaft?
----
Reassembly is as easy as disassembly - probably easier(!). Just make sure the sector gear is TIGHT on the pivot shaft splines before you stick the cover back on!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.