Farmall & IHC Tractors Discussion Board |
Re: IH 685 PTO
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on September 05, 2000 at 18:01:10 from (206.228.214.223):
In Reply to: IH 685 PTO posted by Tim on September 05, 2000 at 15:39:20:
I think your tractor is the same as a 574/674 in the pto areas. That being correct, I think you may have two problems. To keep the pto lever in position I have had to file a detent in the engaged position of the forward part of the slot that is similar to the detented position that is in the back of the slot that keeps the control arm disengaged. Now, with the modification, to engage the pto I move the lever forward and then slightly to the right and it stays in the notch. As for the slipping it sounds as if the PTO clutch pack is out. Refer to a post a ways under this concerning a 674.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|