Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Front wheel wobble on a H


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Andy Martin on September 03, 2000 at 19:48:13 from (38.31.74.217):

In Reply to: Front wheel wobble on a H posted by james morris on September 03, 2000 at 03:04:51:

You have had lots of good suggestions. My experience is that the lower upper bolster bearing is usually the culprit.

This is the bearing around the vertical shaft that comes down from the steering gear. The bearing is just above the level of the frame rails. It makes a lot more difference than worn u-joints because the worm gear intercepts the wobble. I have never had a gear so sloppy that the front end wobbled, but I may have been lucky. But the bearing I am talking about is worn out on lots of old Farmalls.

To check this bearing, jack the front of the tractor up so the front wheels hang free if it is narrow front. Grab them and push side to side. If the bearing (it is a sleeve bearing with a ball thrust bearing) is worn the wheels and everything will move side to side. The zerk just above the hand-crank shaft in front center of the tractor greases these bearings.

If you have a wide front tractor just have someone wiggle the steering wheel back and forth and look up under the front of the tractor and see if the bottom of the steering shaft is moving sideways instead of turning. You can do a lot on wide fronts by giving it a little more toe-in, I bet your tractor is narrow because you have this problem.

It is a tough job to get the old sleeve out and the new one pressed in. I am running one tire flat now on an M I baled 11,000 bales with this summer to wait until cooler weather to get the bearing changed. The M's and H's are built the same, just different sizes.

If you have to replace this bearing, have the steering shaft (upper bolster) checked for cracks by somebody who can check crankshafts. I had one break off too, and fortunately I was in a field. I always remember it when I'm ripping down the highway in 5th gear, pulling a load, and start bouncing over a rough road. High pucker factor to realize your front wheels could both fall off together!


Follow Ups:




Post A Followup

:
:

: Re: Re: Front wheel wobble on a H

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy