Posted by LJD on December 10, 2011 at 05:44:17 from (67.142.130.17):
In Reply to: Magneto question posted by Machine249 on December 09, 2011 at 17:27:55:
It takes an extra 2000 volts to jump across the rotor to the pole inside the cap if it's new and clean. So if the spark is not as strong as it should be, you can get it out of the coil but not through the cap.
Easy test is to get a big spark plug and break the ground electrode off of it. This way the spark has to jump a 1/4" gap. If that works from coil with a 1/4" blue spark, you know you have enough to got through the cap.
A clean plug gapped at .025" takes around 8,000 volts to fire. If run through a distributor cap and rotor it takes 10,000-11,000 volts.
Gap a plug at 1/4" and it will take 20,000 volts which any good battery coil can make.
Also, points timing must be correct. If you points cause spark when the rotor is inbetween distributor poles, you can lose spark. If points are timed right, the rotor will point at a pole when spark occurs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
