Do the finger lay parallel to pressure plate. What is the thickness of the clutch disc. Some discs are thicker than new ones which will cause fingers to be tilted toward flywheel. Some rebuilt pressure plates have been machined too much and fingers tilt away from flywheel. Are all fingers the same, I always check with feeler gauge between finger and throwout bearing after tractor is assembled and in at least three different positions by turning engine. They don't always check out the same in all positions due to misalignment of clutch release brg on carrier. Also, did you assemble tractor with clutch bolted to flywheel or do it the right way and hang pressure plate on input shafts and bolt on from underneath to prevent damage to pressure plate or disc. Next thing, what disc, four pad, six pad. The six pads are not as good at releasing as the four pad. On the four pad, the trick is to bend the wings pads are on so outside edge of pad is a few thousanths of an inch from touching when laying flat on pressure plate. This allows pad to spring away from flywheel for better release. This was something IH came up with after having a tough time getting good clutch release on new 7 and 806 tractors and then again on later series. Also, lube the splines, preferably with molykote spline lube. Hey, I have been there, many times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.