I think I may have found the cause for my blown gasket. When I cleaned up the block surface, I found that there is a decent size gap between the sleeve and the block. I now recall that the machine shop that rebuilt the head for me 4 years ago also lent me plates to use for pressing the sleeves in. They recommended filing a slight chamfer on the block so that the sleeves would start easier. This is probably fine to do on just about any other motor, but not this one. As Pete noted, the gasket matches the underside of the head and not the sleeves, the cylinder gasses can get into this "v" caused by the chamfer and then work their way under the gasket until they break out into the cooling ports. So looks like I really shot myself in the foot on this one. :oops:
I have no way of getting the block into a machine shop to machine it down until the v groove is gone and even if I did it would probably require 50-100 thou to completely get it. I have no idea what this would do to the compression ratio.
Now my question is: is there anything I can use to fill that v groove? JB weld? Devcon? It is .010-.020 wide and .10-.05 deep.
Eventually I suppose I will learn to completely think through what someone recommends.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.