But hey, at least you get potpouri, all I ever get is mouse crap and corn!
As for the compression -
First, I'd say measuring it by amount of wind passing one's finger isn't exactly an accurate measure! Remember these are very low compression engines to begin with. The difference between "perfect" and "not so good" might not be detectable with a finger.
I'd get a cheap compression gauge and check it before wasting any time with it.
But let's say the compression IS truly too low.
I'd dump a little oil in each spark plug hole and retest it. If compression comes up, you've got worn rings.
Pull the valve cover, crank the engine and watch each valve. If they're stuck, it should be pretty obvious that they aren't coming back up when the rockers lift.
If they appear to be working properly - then check the valve lash. (don't get all super accurate, just a ballpark check) The valves could be coming back up to close, but never making it all the way to seat.
It's unlikely they'd be worn so bad that they'd be no compression - the engine would have stopped working before they got that bad. BUT it is possible somebody messed around with them and cranked them too far down.
If valve lash is in the ball park, and they're all moving, then I'd pull the head and take a look. Make sure the head gasket isn't blown apart.
Do a leak test on the head. Put the head on its side and fill the exhaust/intake ports with kerosene. Watch the valves. If kerosene is dripping past a valve, it's too worn to seal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.