Posted by Berghandler on December 05, 2011 at 11:24:40 from (207.67.93.212):
I have restored a 1947 w/regulator 6 Volt H. I did nothing to the engine, govenor, carb or manifold because it was running faily good prior to teardown. I cleaned carb by putting entire carb in carb cleaner. I also replaced all plugs, plug wires, points and wiring. I now try and start and it starts O.K. but at a high RPM and I can"t throttle down at all. I have rechecked the govenor connection where the keyed shaft goes into the carb to fit with the mating part that controls the manitfold butterfly and It"s O.K. I haven"t done any adjusting to carb because it was O.K. before teardown, but the sediment bowl was very dirty and I beleive that the carb had to be sucking fowl gas. It now is all clean but start"s off at high RPM. I am going to check the throttle linkage yet because that"s the only other thing I had diassembled but I think it"s also O.K. Any ideas why??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.