Posted by Owen Aaland on December 03, 2011 at 01:07:21 from (216.47.33.145):
In Reply to: Hey Wardner posted by Jason the Red on November 29, 2011 at 16:50:55:
To me it looks like there is one gear in the front and three gears all in the same vertical plane on the back side. In order for the output shaft to rotate the same direction as the input shaft there has to be an odd number of gears in a single plane. The gear tooth count Jason gave was one 35 tooth gear in the front and 16, 19, and 14 in the rear. In order for the output gear, 14 tooth, to rotate the same direction as the input gear, 16 tooth, the middle gear, 19 tooth, must be an idler gear.
The ratios work out to be in the front 35/35. On the back side the ratios are 16/14 with the 19 as an idler gear and 14/35 provided the tractor has the standard 4th gear. Maybe I did the math wrong but I took :
35/35 X 16/14 X 14/35 = 1/1 X 8/7 X 2/5 = 16/35 = 2.1875
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.