Posted by CenTex Farmall on November 28, 2011 at 22:11:30 from (166.147.65.80):
In Reply to: Sleeve Gouges posted by 400D Guy on November 27, 2011 at 11:09:59:
To me it looks more like a piece of trash went through it at some point. I've torn down engine before that had broken rings and there was no damage from that. In one case I pulled down a running engine that had a fracture that went through piston and both compression rings and there was no cylinder wall damage.
Normally the ring exerts some outward pressure against the cylinder. If broken for some reason, that outward pressure is lost and the ring no longer seals but will not necessarily tear up the cylinder. The ring is now just along for the ride.
The clearance Jim was referring to is the vertical ring clearance. The clearance _behind_ the ring is a bit more.
The problem you have now is that the further you go into the engine the more and more little things you will find that will bug you even though the engine will still run. First the head gasket problem and now you find this. I've been down this road many times myself!
It may be possible, if the cylinder wear does not exceed limits and if the piston is not damaged, to smooth the gouges then run a hone through this cylinder and put new rings on it and go. It's hard to tell from the photo how fresh the damage is. Was the compression good on this one? You may be able to live with it until you're ready for a major overhaul. However, if you end up taking the block out to for machine work for the head gasket issue then it would be wise to check all the cylinders and pistons for wear and consider your major overhaul at this point.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.