Posted by Mike1972chev on November 22, 2011 at 06:09:45 from (75.149.81.173):
In Reply to: 10-20 head stud posted by oldiron29 on November 22, 2011 at 03:54:37:
I have heli coiled a few head studs that run into the water jackets with good sucess.If you do this,be sure and use some "blue devil" block sealer when you are done.Get it at your MAJOR parts places.
Another option which is great is a threaded insert from McMaster- Carr.
The advantage with these is they are not the "next size up" in threads like a heli coil.If your threads were BADLY damaged,the appropriate heli coil for that bolt size MIIIIIGHT not be tappable to the heli coils threads ???? The only limiting thing with these is if the headbolt sits close to a cylinder or sleeve it might not allow for the newer,larger diameter of the oversized inset to fit????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.