Posted by Tom Fleming on November 22, 2011 at 04:09:32 from (206.193.250.146):
In Reply to: 10-20 head stud posted by oldiron29 on November 22, 2011 at 03:54:37:
Oldiron, I would tend to agree with you. There are a couple of ways to attack this in my opinion. The easiest one has some risk to it that you will have to remove the head again if it doesn't work. for the studs that "don't hold" well, will they at least slightly snug? If so, get some JB weld. Chase the threads again in those holes with the correct size tap. Apply the JB weld to the holes and also the studs. Install studs to just slightly snug.
Let it setup for 24 hours, and then go ahead and install the head again.
Other way would be to drill and tap the holes out to the next size if there is enough meat in that area of the block. Have a machine shop turn down the new bolts so you have the larger thread going into the block, and the correct size for the rest of the bolt. You will have to cut new threads onto the custom bolts, but should work just fine. Also, you will probably have to use Locktite for the custom bolts to hold them in the block, as they will not have a shoulder to rest on for tight, and will turn when you go to torque the head on. You could also use a punch to peen "lock" then in place, but be careful not to over peen them.
Last option would be to use a Helicoil if you can find the right size. also, a good choice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
