Posted by clayshootr on November 14, 2011 at 05:55:13 from (155.77.200.253):
Over the weekend I purchased a 1959 560 Diesel, and have a few questions on it.
It seems to blow a lot of white smoke and misses on a cylinder or two after it is started. When I purchased it I figured this would clear up when it got up to operating temp. So when I got it home I changed the engine oil, cleaned the oil bath air filter, filled it up with fuel and hooked up my 13 ft. JD disk. I spent about 2 hrs in the field with it.
When it is under a load it cleans out and pulls on all cylinders with no white smoke. When the disk is raised out of the ground to trun around it goes back to missing and smoking??
It seems to have plenty of power when pulling. ( I think it might out pull my JD 720D) Just did not know what to check first.
Thanks for any advice!
BTW this is my first Farmall. I have been a 2-cyl JD guy for the last 20 years. I really think I am going to enjoy this tractor when I get it running right.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
