I've bought seal kits from here, and local at the dealer.. only about 3-4$ difference many times.
so far I've never had a seal or gasket issue between the two.
I will say that I like CNH packaged lift piston orings better than some of the no names, and as far as ford n hyd pumps, i have seen issues in gaskets that were not the same thickness as oem causing problems.. but it's rare.
the only *real* issue I've ever come across was steering gearbox thrust bearings... I got some chinese ( timken !!! ) bearings and the cage was the wrong profile, so as correct preload was set, the cage would crush.. went thru 2 sets of these crap bearings before I switched to another supplier / manufacturer and got some bearings that were correct. ( these ar ehte worm thrust bearings used commonly in the 47-64 and possibly later manual steering boxes )
I was surprised to see made in china printed on the timken bearing boxes.. and not surprised that they crushed. I noticed this on a steering rebuild on a 4 cyl 2000 I did earlier this year. had that box apart about 3 times trying to get it adjusted.. couldn't figure out where the play and binding was till i noticed the bearings kept crushing and cages popping :(
figures.. and I'm no newb when it comes to a ford steering box.. but them dern cheap bearings were perplexing...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
