Farmall & IHC Tractors Discussion Board |
Erratic throttle operation on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Ed on August 23, 2000 at 18:49:58 from (209.240.200.84):
I recently put a new kit in the carborator of my 1947 H. After installing it and setting the fuel adjustment screws approximately 1 1/2 turns out from stop it started fine and ran good but I had no throttle control. It was at high idle no load. I took it apart and found I had the throttle shaft out of place on the butterfly valve control. I took off the angle plate up front and the shaft bolts on both ends of the throttle shaft and got it where I had control. It idles real nice and tops out ok, not sure of rpm, but the throttle is inconsistant. The engine does not respond to the throttle settings every time. Sometimes I can give it full throttle and it only seems to come a little above idle. Then you can shove the throttle back to idle and the engine will keep running at a high rpm. I have been into this about three times and my success has not been very good. Any ideas or help would be appreciated. Thanks Ed
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|