Farmall & IHC Tractors Discussion Board |
Re: Re: Belly pump on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on August 22, 2000 at 05:49:43 from (129.37.117.44):
In Reply to: Re: Belly pump on H posted by The Red on August 22, 2000 at 05:17:58:
I would think that sticking a screw driver in the inlet port to hold the gears to unscrew the coupling would damage the pump gears. I know for sure that it will if the coupling is as hard to get off as the one was on my MD. I ended up taking the pump apart. I tried holding the gear between blocks of wood in a vise and hammering the coupling with a bar in it. Still no luck. The blocks just walked out of the vise. I finally used a hole saw to cut a hole the size of the gear in a two inch thick piece of oak. I split that down the center of the hole and cut off about 1/2 inch more to clear the other gear shaft. Then I clamped the gear in the vise with that. It took about 10 hard blows with a 1 lb hammer to break the coupling loose.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|