Posted by Tom Fleming on September 27, 2011 at 17:47:03 from (67.20.249.95):
In Reply to: Timing on a 46 H posted by Ofischill on September 27, 2011 at 12:34:31:
Well, that depends. I learned how to time a distributor by listening to the engine as you turn it. That doesn't make you "perfect", but it sure will get the job done if you are not looking for the absolute best setting for your engine. If good enough is good enough, run the engine up on full throttle, then with the base loose, turn the distributor one way, then the other. When you get max RPM's and a clear, full exhaust sound, you are on the money.
Otherwise, use a timing light OR..... These tractors were all designed to have the initial timing on TDC. Getting to TDC is relatively simple. with the ignition off, remove plug #1, and loosen the rest. Turn the engine over until your feel the compression stroke starting. I use a wooden dowel rod in the plug hole to "feel" the piston coming up as you slowly keep turning it over by hand. Once you have #1 at TDC, then take the cap off your distributor. rotate it until the rotor is point at approx 2 oclock (#1 plug wire on the cap.). you are now timed to TDC.
Rotating towards the engine (CCW) advances the timing. Rotation away from the engine (CW) retards the timing. If you use a starter and not the hand crank, you can advance your timing a bit, but not too much.
My advice is to time it to TDC, and let the distributor handle the advance it was designed for.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
