Farmall & IHC Tractors Discussion Board |
Re: Belly pump on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john d on August 21, 2000 at 21:03:29 from (205.188.199.33):
In Reply to: Belly pump on H posted by Nich on August 21, 2000 at 19:28:45:
The belly pump is heavier than you may expect. Remove the lift lever, the pipe ports on both sides of the tractor, and the filler pipe. Then the access plate at the back of the pump on the bottom of the tractor. This will give you access to the drive coupler on the rear of the pump and front of the transmission shaft. The coupler may have a cotter key in it with a removeable square drive key which makes re-installation easier. Once all that is past, remove two bolts from the bottom of the pump on opposite corners. If you are working by yourself, you may want to consider installing 2 pieces of 12" long threaded rod and a couple of nuts (with flat washers) on them into the empty holes. This will allow you to remove the two remaining bolts and lower the pump by unthreading the nuts on the the threaded rods. (NOTE: when installing the threaded rods, use two nuts jammed together to allow you to tighten the rods into the holes so they do NOT back out when lowering the pump!) When the pump is held by the nuts on the rods, remove the last two bolts and lower the pump safely. If you have a strong friend to help, you may skip the part about the threaded rods and support the pump as it comes out. Don't let this thing suddenly drop on your foot, or worse yet, your head!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|