Posted by JRSutton on September 20, 2011 at 06:30:17 from (75.130.109.233):
In Reply to: Re: M locked up posted by sflem849 on September 20, 2011 at 06:00:32:
The way I look at it is that it's all in there anyway, so any of it that you can remove, the better off you are.
I hone what's there before freeing it up, that way most of it is dry enough to vac right up - then soak it, knock it free, then hone any areas that get exposed after moving it. Usually what's below the pistons isn't as bad.
And when I say hone, I'm not talking anything heavy, just enough to remove the stuff that sticks out. You don't want to try to undo any deep pitting, you'd have to take too much material off. The walls usually remain discolored.
get most of remaining junk with kerosene soaked rags. Oil it all when done.
I suspect the problem of corrosion is very different in different areas of the country. In the northeast, we have a lot of wild temperature changes, lots of condensation and moisture getting into everything. I've seen cylinders that have sat for less than two years that you'd swear were sitting for 20.
I know the soak and go method would work on them, but when they're that bad, there's no way you're not taking years off the life of the rings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.