Posted by Eastsider on September 18, 2011 at 16:02:28 from (96.3.32.189):
Hi all:
Here is a good one...We have an Independent Gang Rear Section for the 2c-254a cultivator. The only tractors this fits on is the Super C and 200 style of fast hitch receiver. The problem we have is that the ends of the bars where you mount the scratchers are what I call "diamond" shaped instead of "square". Meaning, that when on the tractor, the ends have the point in the air instead of a flat. So, mounting clamps for regular bars are tilted out of whack. The parts book calls for the regular clamp that you use on the rest of the system. My question is, how do you mount your scratchers on the back??? I have the proper clamp for the middle of the system, but the end ones befuddle me. My thought is to cut off the ends and give them a partial rotation so the flat is facing the right way so the clamp works. Does anyone have experience with this setup??? I have one complete setup as seen here and one with the main frame and top clamps. Here is the picture of what I am referring to.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
