I would NOT use old rod bearings with new pistons and rings. You would have a tight cylinder assembly and loose rod bearings. That can be a recipe for disaster!
You might be able to use the old mains but before you do, get some Plasi-Gauge at you local parts store (not expensive) and follow the instructions that come with it. It will tell you what the gap is between your crank main journals and main bearings. Your Tractor Repair Manual gives that gap spec. If that spec is larger than specified, then you run the risk of having low oil pressure. A thing you really don't want with new rings and rod bearings.
Another tip is to measure your rod bearing journals with a micrometer. You will probably find that they are a few thousandths undersize (again, you repair manual gives you the measurement for your rod journal diameter). They sell .002 over rod bearings on this site and other parts sites. That way you don't have to have your crank turned at a machine shop to .010 over if your rod journals are only out of spec by just a few thousandths.
The only visual inspection that is reliable is, if you can see copper showing on ANY of the bearings then they are most likely no good. All of them.
I don't have a manual for your tractor or I would have included the specs you need. If you don't have a manual I suggest you pick one up. It will be useful as long as you own your tractor and repair it yourself. There are LOTS of helpful guys on this site and if you don't want to invest in a manual, I'm sure someone will post them for you if you ask.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.