Farmall & IHC Tractors Discussion Board |
Re: Re: 450D oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Redfan on August 20, 2000 at 03:20:39 from (203.87.53.9):
In Reply to: Re: 450D oil posted by Jon....Another thing on August 19, 2000 at 18:11:10:
Yes John, same oil in pump. One tip you may or may not have picked up here before, when shutting the motor down, allow it to idle back for a good while if it is hot. When you think it has cooled sufficiently, snap it over to petrol mode and turn off the petrol tap. This allows the auxilliary combustion chamber to dry out, making it easier to start next time. Once the motor is stationary, snap the levers back over to diesel mode, this seats the starting valves which allows them to cool at the same rate as the head, thus preventing them from warping. It is a good system, if it is treated properly, it will be very good. Regards, Redfan.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|