Posted by Bob M on September 12, 2011 at 17:23:38 from (69.207.87.100):
In Reply to: Re: First hemi?? posted by John T on September 12, 2011 at 14:16:28:
Hey John T...
Beyond marketing hype - which from an engineering perspective is worthless(!) - the advantages of a hemispherical head are:
1 - Spark plug is centrally located in the combustion chamber. This promotes faster and more thorough combustion with less chance of detonation - especially at higher compression ratios.
2 - Has space for larger diameter valves, hence better engine breathing than other head designs.
Combined these permit slightly more power output per cubic inch - especially at wide open throttle - than other head designs.
The downside is a more complicated (expensive) valve mechanism, and a physically larger rocker box to enclose it. Thus racing hemis were often referred to as the "elephant motors" on account of their large envelope.
Incidentally virtually all large aircraft piston engines after about 1920 employed hemi heads.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.