Farmall & IHC Tractors Discussion Board |
Re: Re: cub low on oil pressure
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Coughlin on August 19, 2000 at 05:39:04 from (172.164.130.202):
In Reply to: Re: cub low on oil pressure posted by p on August 18, 2000 at 06:33:50:
It would be a good idea to do what "p" recommends. Here's another thing. Early Cubs had a oil filter cover made of white metal. These had a tendency of loosening up after an oil change. The result was that the oil pressure would drop. Re-tightening would do the trick (never over tighten). Later Cubs had a cast steel cover and many older Cubs were converted. The white metal covers were smooth and the cast steel had a ridge around the perimeter. An old IH service man told me about this years ago; the '48 Cub I grew up with had the white metal and was prone to loosing oil pressure (I always carried the right wrench). Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|